SealMaster CrackMaster Hot Pour Crack Sealants

CrackMaster 6690 Type I

The ideal product for the contractor who wants a single product to use in both road and parking lot applications. Meets ASTM D6690 Type I (formerly ASTM D1190).

Sizes Available

50 lb. box with two 25 lb. cubes per box.

Coverage

Use the following chart as a guideline for estimating material requirements (based upon pounds of material needed for 100 feet of cracks):

Crack Width Depth lbs. / 100 ft
3/8″ 3/8″ 6.9 lbs.
1/2″ 1/2″ 12.3 lbs.
3/4″ 3/4″ 27.8 lbs.

NOTE: The above coverage rates are only a guideline. Actual material usage may vary due to width of application and thickness of material above pavement surfaces.

Download

SDS (PDF)
Spec Sheet (PDF) – English | Spanish
Catalog

Description

CrackMaster 6690 Type I is a premium quality crack and joint sealing material that resists tracking at elevated temperatures and remains flexible down to -10°F. When melted and properly applied it forms a resilient crack sealant for both asphaltic and cementatious pavements. CrackMaster 6690 Type I forms a lasting seal that resists tracking in warm climates.

Uses

CrackMaster 6690 Type I is designed to seal expansion joints, longitudinal and transverse cracks, joints between concrete and asphalt shoulders, and random cracks in both asphalt and concrete pavements. It is ideally suited for both roadways and parking lots.

Mixing Procedures

Use material as supplied. Do not blend with other materials. After CrackMaster 6690 Type I is melted it should be agitated or recirculated.

Application

Apply heated CrackMaster 6690 Type I using either a pump and wand system or a pour pot. For best results the sealant depth to width ratio should not exceed 2 to 1 (i.e. 2-inches deep to 1-inch wide). The cooled sealant height should not exceed 1/8″ above surrounding pavement. Using a sealing shoe or squeegee, band the material 2 to 3 inches wide over the crack.

Important

Protective apparel is recommended with application of CrackMaster™ 6690 Type I. The extremely hot material will cause severe burns on contact with skin. OSHA Safety Regulations require workers to wear the following types of safety attire (see current OSHA/Safety Regulations for additional information): Hard hat with face shield; long sleeved shirt buttoned at the wrist; heat resistant gloves; long, cuffless pants; and safety toed work boots. Make certain all area around melter is clear of all debris and flammable materials. Avoid breathing vapors. Use with adequate ventilation.

Clean Up

Wash tools in water before material dries.

Unit Size Unit Weight
50 lb. Box 50 lbs.