MasterSeal Ultra Tech Data

Product Description

MasterSeal Ultra Pavement Sealer is a clay-stabilized, asphalt emulsion pavement sealer designed to protect and beautify asphalt pavement. MasterSeal Ultra is a ready to apply material that is factory blended with water, aggregate and polymer, providing a highly durable slip-resistant coating. MasterSeal Ultra Pavement Sealer meets ASTM D8099/D8099M-17 Standard Specification for Asphalt Emulsion Pavement Sealer.

Recommended Uses
MasterSeal Ultra is ideal for protecting and beautifying all types of pavement surfaces including parking lots, shopping malls, airports, driveways, roadways and more.

Estimated Material Requirements
One gallon of MasterSeal Ultra will cover approximately 70 – 82 square feet per gallon per coat (7.75 – 9.1 square yards per gallon per coat).

Application Rate
Apply MasterSeal Ultra at a rate of 70 – 82 square feet per gallon per coat (7.75 – 9.1 square yards per gallon per coat). Application rates may vary due to pavement porosity and method of application.

Performance Characteristics

Surface Preparations
Surface must be clean and free from loose material and dirt. Cracks should be filled with SealMaster Cold or Hot-Applied Crack Filling Materials. Oil stains should be cleaned and primed with SealMaster Oil Spot Primer.

Application Equipment
MasterSeal Ultra shall be applied by mechanical squeegee/brush equipment or spray equipment capable of spraying coatings with sand. Equipment shall have continuous agitation or mixing capabilities to maintain homogeneous consistency of mixed material throughout the application process. Truck mount or self-propelled squeegee/brush equipment shall have at least 2 squeegee or brush devices (one behind the other) to assure adequate distribution and penetration of MasterSeal Ultra into bituminous pavement. Hand squeegees and brushes shall be acceptable in areas where practicality prohibits the use of mechanized equipment.

Mixing Procedures
Mix MasterSeal Ultra thoroughly before applying. If needed, a small amount of water may be added to facilitate application.

Application Procedures
For optimum performance and durability apply a minimum of two coats of MasterSeal Ultra. A third coat may be applied to high traffic areas such as parking lot entrances, exits and drive lanes for added durability. Allow each coat to dry thoroughly before applying successive coats. Allow final coat to dry for 24 hours prior to opening to vehicle traffic.

Application Weather Conditions
MasterSeal Ultra shall not be applied when temperature is expected to drop below 50° F during application and for a period of at least 24 hours after application. Do not apply if rain is imminent or forecast within 12 hours.

Line Striping and Traffic Markings
Use SealMaster Traffic Paints for line striping and traffic markings.

Packaging and Availability
MasterSeal Ultra is available for plant pick up or bulk tanker load quantities. MasterSeal Ultra is supported by a national network of SealMaster manufacturing and distribution facilities along with a national network of qualified applicators.

Warranty and Disclaimer
The statements made on this technical data sheet are believed to be true and accurate and are intended to provide a guide for approved application practices. As workmanship, weather, construction, condition of pavement, tools utilized, and other variables affecting results are all beyond our control, the manufacturer warrants only that the material conforms to product specifications and any liability to the buyer or user of this product is limited to the replacement value of the product only. The manufacturer expressly disclaims any implied warranties of merchantability or fitness for a particular purpose.