CrackMaster™ Mastic PL Parking Lot

CrackMaster™ Mastic PL Parking Lot

CrackMaster Mastic PL Parking Lot is a hot-applied polymer modified asphalt mixed with specially designed aggregate and modifier combinations that is chosen to properly fill wide cracks and defects, thus allowing for prevention of water infiltration while restoring and improving traffic quality.

Description

CrackMaster Mastic PL Parking Lot is a hot-applied polymer modified asphalt mixed with specially designed aggregate and modifier combinations that is chosen to properly fill wide cracks and defects, thus allowing for prevention of water infiltration while restoring and improving traffic quality.

Uses

CrackMaster Mastic PL Parking Lot is designed as a long-term repair solution for wide thermal cracks, fatigue cracking, rutting and depressed, broken-up areas in parking lots and intersections. CrackMaster Mastic PL Parking Lot can be used use around solid structures in flexible pavements like manholes, gutters, and drains.

Read and follow application instructions before use.
This product must be heated using indirect heating methods, either a double boiler or hot oil circulating kettle. Equipment must be capable of maintaining constant agitation to the material to keep aggregate suspended evenly.

Application

Proper surface preparation facilitates adequate adhesion and consequently the maximum life of the mastic sealant. In order for proper adhesion, the crack/joint must be free of moisture, dust, loose aggregate, and other contaminates. The substrate and air temperatures must be 40°F or above and rising. Use oil-free compressed air and heat to clean and dry the joint immediately prior to sealing.

The melting kettle should be a double boiler or conventional oil jacketed unit equipped with an agitator and temperature control devices for both the material and heat transfer oil. Carefully insert small quantities of CrackMaster Mastic PL Parking Lot into the melting equipment while the agitator is turned off. Load material slowly to avoid splash back. After the initial load has reached the recommended pouring temperature, fresh material may be added to the melter as required. Melt only the material that will be used during that day. Purge material remaining in the kettle lines at the end of each sealing operation. The material may be safely reheated and can be applied using a pressure feed wand system or a pour pot.