OptiPave Asphalt Surface Sealer
Protect, Beautify & Extend the Life of Asphalt Roads
OptiPave is a clay-stabilized asphalt emulsion surface sealer designed to preserve and protect asphalt roads. Its ready-to-use formula replenishes pavement binder lost through oxidation and weathering while helping protect the pavement surface and restore a deep, rich black appearance. Designed as an economical treatment for low-traffic roads, OptiPave requires no dilution and is applied in a single spray coat for fast application with minimal impact on traffic flow.
Features & Benefits
Replenishes Lost Asphalt Binder
OptiPave replenishes valuable asphalt binder lost through oxidation, weathering, aging, traffic wear and other forms of environmental distress.
Ready-to-Use Formula
OptiPave is supplied ready to use with no dilution required, reducing mixing and preparation before application.
One-Coat Application
OptiPave is designed for a single spray application, providing an economical pavement preservation treatment with minimal impact on traffic flow.
Deep, Rich Black Appearance
OptiPave restores weathered asphalt with a deep, rich black appearance that renews the look of low-traffic roads and streets.
Recommended Uses:
- Low-traffic roads
- Low-traffic streets
- Neighborhoods
- Gated communities
- Airport taxiways
- Highway shoulders
- Cul-de-sac roads
- Top coat for slurry and chip seal
Application Guidelines
SealMaster
OptiPave
Asphalt Surface Sealer for Roads
Surface Preparation
Repair major pavement defects before applying OptiPave. Fill pavement cracks with the appropriate SealMaster hot-applied or cold-applied crack filler. The pavement surface must be free of dust, dirt, debris and standing water before application.
Mixing Procedures
OptiPave is supplied ready to use and should NOT be diluted.
Application
OptiPave is designed for single-coat spray application only. Spray application helps maintain the existing pavement profile and porosity while allowing the material to penetrate the pavement surface. Brushes can be used along edges and in hard-to-reach areas where spray application is not practical.
Important:
OptiPave should NOT be applied to smooth pavement. OptiPave relies on the existing roughness, porosity and profile of the pavement to maintain proper vehicle traction. Apply only to pavement with sufficient porosity and surface profile.
For proper application:
- Apply in one spray coat only
- Do not apply by squeegee
- Do not overapply
- Do not exceed the recommended coverage rate
- Maintain the existing pavement porosity and profile during application
Temperatures must be above 50°F during application and remain so for at least 24 hours afterward. Do not apply when rain is imminent or forecast.
Coverage
When applied, one gallon of OptiPave will cover approximately 50-75 sq. ft. per coat or 5.55-8.33 sq. yd. per coat.
NOTE: Coverage rates may vary depending on the pavement age, porosity and application method.
Available Sizes:
5-Gallon Pail – 50 lbs. | 55-Gallon Drum – 555 lbs. | Bulk
Available Color:
Black
Find the Right Pavement Sealer for Your Project
Not sure which pavement sealer is right for your project? SealMaster’s highly trained professionals can evaluate your pavement, recommend the right products and determine the appropriate mix design for your application. Contact SealMaster today to schedule a free pavement inspection or speak with one of our professionals.