Polymer modified fiber sealant containing approximately 5% polyester fibers. Designed for use in oil-jacketed kettles. Ideal for use on roads and highways. Moderate to hot climates – flexible to -0°F.
50 lb. box with two 25 lb. cubes per box.
Use the following chart as a guideline for estimating material requirements (based upon pounds of material needed for 100 feet of cracks):
The above coverage rates are only a guideline. Actual material usage may vary due to width of application and thickness of material above pavement surfaces.
CrackMaster PF is a single component, hot applied fiber modified crack and joint sealant. When melted and properly applied it forms a resilient crack sealant for both asphaltic and cementatious pavements. CrackMaster PF forms a lasting seal that resists tracking in warm climates.
CrackMaster™ PF is designed to seal expansion joints, longitudinal and transverse cracks, joints between concrete and asphalt shoulders, and random cracks in both asphalt and concrete pavements.
Use material as supplied. Do not blend with other materials. After CrackMaster™ PF is melted it should be agitated or recirculated.
Apply heated CrackMaster™ PF using either a pump and wand system or a pour pot. For best results the sealant depth to width ratio should not exceed 2 to 1 (i.e. 2-inches deep to 1-inch wide). The cooled sealant height should not exceed 1/8″ above surrounding pavement. Using a sealing shoe or squeegee, band the material 2 to 3 inches wide over the crack.
Protective apparel is recommended with application of CrackMaster™ PF. The extremely hot material will cause severe burns on contact with skin. OSHA Safety Regulations require workers to wear the following types of safety attire (see current OSHA/Safety Regulations for additional information): Hard hat with face shield; long sleeved shirt buttoned at the wrist; heat resistant gloves; long, cuffless pants; and safety toed work boots. Make certain all area around melter is clear of all debris and flammable materials. Avoid breathing vapors. Use with adequate ventilation.
Wash tools in water before material dries.